I had thought about using a 12 volt wall adapter at 1.5 or 2 amps, however, a 9 volt will run 10 LEDs on a 555 timer.
A 555 timer will output 200 milli-amps.
10 LEDs, each needing 20 milli-amps = 200
10 navigational LEDs will take up the 555 timer ideally. This leaves the 4 strobe lights to deal with which is another 80 mA. I expect to wind up using a 556 timer (which is 2 555s in one chip) output 2 x 200 mA.
Remaining constant on lights could be done with a few 9 volts hooked up in parallel for the needed current.
I'm just too short of time but I have the 555 timer onthe breadboard now with an LED and I'm happy with the on/off rate for the navs.
Topic: 9 volts and timers and breadboards oh my! (Read 3580 times)